Many people still don't know the correct installation method of child safety seat and what is the correct installation method of child safety seat. Now let's take a look!
The correct installation method of the child safety seat: First, fix the ordinary safety belt, pull out the safety belt, pass through the two pull rings on the back of the child seat, and fix it in the safety buckle; 2、 ISOFIX system fixation, put the child seat on the seat, pull out the safety belt, pass through the back and fix one side, tighten and fix it in the safety buckle; 3、 LATCH system is fixed, pull out the safety belt, pull it up through the back, and buckle it in the safety buckle on the top.
1. Ordinary seat belt fixation
The common way to fix the safety belt is to use the most common method. After pulling out the safety belt, it needs to pass through the two pull rings in the middle from the rear side of the child seat, and after tightening, it is fixed in the safety buckle below. Because only the safety belt passes through the safety buckles on both sides, the firmness is not particularly in place, so it can be pulled inward at the upper position and pulled into the headrest of the child seat, so that the gap can play a fixed role.
2. ISOFIX system fixation
This system is different from the common safety seat fixation method, because there are two obvious fastening buckles under the seat. Therefore, when fixing, it is necessary to put the child seat on the seat in advance, put the safety belt in from the back, and tighten it from the other side to the middle. When tightening, you can see that the upper and lower safety belts are pulled together, and then put it down and fix it on one of the fastening buckles.
3. LATCH system fixed
The system belongs to another mode, because when you carefully observe the upper position of the rear seat, you can clearly see a metal gusset plate. When you lift the gusset plate, you can see a metal pull ring. You need to buckle the safety belt into it after passing through the operation to play its role. So you need to pull out the safety belt in advance, and also need to pass through the two plastic fasteners on the back, then pull it up and buckle it onto the metal ring on the top.